Roof Fall Protection Plan

3 3 fall protection work plan 3 3 1 fall hazards in the work area determine what fall hazards exist in the work area.

Roof fall protection plan.

This article focuses on roof work but fall protection is also usually needed when. A lack of fall protection damaged fall protection equipment or improper setup will increase their risk of falling from height. Check all that apply and then refer to the next section for the appropriate fall protection system to implement. A written fall protection plan will be developed and implemented when a fall hazard of 25 feet or more exists or when a safety monitor and control zone is required.

Working six feet or more above lower levels put roofers at risk for serious injury or death if they should fall. The intent of the plan is to. A site specific fall protection plan will incorporate many items including. Factories required to have a safety and health management system may use the required documents to constitute.

A fall protection plan must be developed and evaluated on a site by site basis. Ladders perimeter edges scaffolds leading edge work decks roof edge forming pouring stripping slab roof openings. Prior to permitting employees into areas where fall hazards exist all employees must be trained regarding fall protection plan requirements. 2 1 2 the fall prevention plan may consist in parts of existing documentation e g risk assessment.

Any employee working more than 6 feet above ground or above a lower level needs to be protected from falls by one of several osha approved methods see osha fall protection requirements facing page. Fall protection requirements falls are the leading cause of work related injuries and deaths among roofers. Inspection of fall protection devices systems must be made to ensure compliance with osha and company name internal regulations. Site location address description work area tasks site specific fall hazards e g maximum height s roof slope if applicable proximity to power lines ground cover etc.

Assist workers and supervisors to identify the fall hazards of the site before work begins at heights. It is recommended that builders discuss the written fall protection plan with their osha area office prior to going on a jobsite.